Used Haas Rotary Table, Indexer Page
|
Below is our current list of used Haas rotary tables and used Haas indexers . Most often we get used HRT160, used HRT210 and used HRT310 rotary tables. Besides the items listed below we know of companies that are considering selling excess capacity machines and will contact them for a potential buyer. Let us know what you need. |
Remember, Hit Ctrl-D, to bookmark this site as a favorite.
Used Haas Rotary Tables - Indexers
Haas rotary table: HRT-210 model. 8” face. 2009 unit. SOLD
Near-new condition
Brushless-type motor
Front Front 2 Front 3 Right Left Back Top Cable ends Inquire about this item
Haas rotary table: HRT-310 model. 12” face. Red unit.
New motor installed June 2010
Brush-type motor (conversion cable available from Haas to use on newer VMC's)
Check out it running and see it's accuracy by clicking this link: WATCH VIDEO
Front Front left Right Back Top Inquire about this item
Haas rotary table: HRT-A6 model. 8” face. White unit. SOLD
An HRT-A6 is an HRT-210 with the versability to use chucks, faceplates and collet chucks with an air actuator.
Brushless type motor
Front Back Right front Top Inquire about this item
Haas rotary table: HRT-600 model. 23.6” face. White unit. Manufactured in 2005 SOLD
Weight capacity of 737.5 lb unsupported, or 1475 lb when supported by a tailstock.
Brushless type motor. Very little use - near-new condition!
Front Front 2 Front 3 Inquire about this item
2002 Haas rotary table: HRT-210 model. 8” face. White unit. SOLD
Brushless type motor
SMW ROTARY TABLE WITH CHICK INDEXER SUBSYSTEM PACKAGE
SMW MODEL ET200V ROTARY (8") AND CHICK MML1550 TOMBSTONE
The Indexer Subsystem Package gives VMC users the
capability to machine multiple sides of a workpiece during a single clamping
operation, increasing machining times and accuracies.
The package consists of a Chick MML1550 Multi-Lok Workholding System mounted to an SMW ET200Vrotary table. The interface between the two items is a custom made indexer adapter plate. The opposing end of the Multi-Lok Workholding System is supported by Chick’s tailstock and stub shaft assembly. A custom riser is included to raise the center height of the workholding system to the correct height for maximum swing clearance. Finally, a custom subplate provides the interface between the subsystem and the VMC table, allowing for the entire package to be removed from the VMC table until needed again. All custom items are designed, made and assembled by Chick’s Application Engineers. The table is controled by an SMW model 50 control box using M-codes.
Front right Front right close up Front left Front left close up Right Left Rotary back Tailstock end Grid-Lok plate Control Inquire about this item
WE HAVE CONTROL BOXES FOR HAAS ROTARY TABLES IN STOCK!!!
Office location:
4475 US Hwy 322
Jamestown, PA 16134
(724) 932-2674 Fax (510) 740-3589
Warehouse located in Meadville, PA 16335
